![]() Their construction is similar to conventional flooded batteries, apart from one significant difference. SLA and VRLA are different acronyms for the same type of battery. Type 2: Sealed Lead-Acid (SLA) / Valve-Regulated Lead-Acid (VRLA) Add distilled water if the level is below the minimum mark. There are marks to indicate the maximum and minimum levels of electrolyte.įLA batteries only: Before charging, remove the caps to verify that the lead plates are covered by electrolyte fluid. The caps are either threaded or pull-out style.Īnother way to tell that you have an FLA battery is by its semi-transparent casing, where you will see the water level inside it. On top of the battery are removable caps, one for each cell. Type 1: Conventional Flooded Lead-Acid (FLA) BatteryįLA batteries are a non-sealed wet-cell battery type that uses lead plates and liquid battery acid as electrolytes. A quick Google search will tell you precisely what battery you have if you enter this number. Check out this post to learn what ATV battery numbers mean.Īlso, look for a part number. Here is a list of the different types of batteries you may find on an ATV or UTV and how to tell them apart.Īll batteries should have a label that indicates the battery type, but sometimes these have worn off. What Type of Battery Is in an ATV or UTV? Some types of batteries require a specific charger to charge correctly, or you add a few additional battery-specific steps to the charging process. Never attempt to charge a damaged battery! Step 3: Identify What Type of Battery You Haveīefore you hook up the charger, you must identify your battery type. The battery on my Polaris Sportsman XP1000 is hidden under the front cargo rack cover.Īfter locating the battery, you should visually inspect it for cracks or other damages. Others have the battery readily accessible without removing any parts. You need to make sure you have proper access to the battery. Some ATVs will have their battery hidden behind a plastic cover that needs to be removed for access. The ATV and all accessories should be turned off when charging to prevent sparks. If you don’t have a dry and well-ventilated area that will fit your whole ATV, consider removing the battery from the bike to charge it. Proper venting minimizes the risk of the gas getting ignited by a spark, which may cause an explosion.Ī garage or shed where you can leave the garage door open would be a good location. The battery and charger must stay dry during the whole charging process.Īlso, the battery must be somewhere well-ventilated to vent out any gases from the charging process.Ĭharging a battery causes a chemical process that releases explosive hydrogen gas. Step 1: Park the ATV or UTV Somewhere Dry and Well-Ventilated
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |